Taylor Guitar Repair

South Austin Guitar Repair

 

This poor Taylor had a run-in with a misstep of the wrong foot! The customer had borrowed this guitar from a friend and mistakenly used it for a slipper, or boot, or… I dunno. But it done got broke!

The customer was nervous this guitar might not be fixable in its condition. The breaks were complex and many. When it all comes down, (most) guitars are wood. Everything can be fixed one way or another.

Clamping wood from the outside is no issue, but when a crack is 8″ or longer and going through a surface, is difficult to keep level when re-gluing. I needed to create pressure from the inside-out for the guitar’s top to clamp evenly on the exterior.

For this repair, I went Macguyver and made a new set of clamps from a turnbuckle, threaded furniture foot and… a another, non-threaded furniture foot! The threaded furniture foot provided the necessary torque to apply pressure outward when unscrewed, inside the guitar body. Any additional clamp on the outside can apply pressure inward. The cracks are then equalized between the two sides so not to set unevenly.

Some of the cracks where odd, broken and uneven with the grain where they rest. Overlapping from where they should rest. In some of those occurrences, it’s easier to break the piece off and re-glue than to attempt to force it back.

After all the pieces were glued in place, the back, the guitar back needed to be evened out. Fortunately, Taylor uses light lacquer on their guitars, so it only took a few hours of sanding to get through the finish and level the wood. Once that was even, A few coats of clear lacquer was applied and the back was good as new.